SOILINTER,<soil>,<dir>,<tol>

NOT APPLICABLE TO CURRENT VERSION

Transfer the interaction node area from a 3d excavation model onto a 2d soil model. Both models should be in ACS-SASSI User Interface memory before using this command. The user should select the 3D model to be changed by using the ACTM before using this command. This command will only change the interaction status of nodes on the 2d soil model.

The user must define the interaction node on the 3d model before using this command. The 2d soil model should always be defined along the x-z axis. The dir command allows the user to select if the x-z area or the y-z area of the interaction nodes will be applied to the 2d soil model. the tol argument is a floating point distance past the interaction area where the interaction nodes will be created in the 2d soil model.

• soil - the 2d soil model number
• dir - selection flag
  • 0 - X direction
  • 1 - Y direction
• tol - distance outside of the excavation volume extent to include interaction nodes in the 2d model.