AOPT,<EQUAKE>,<SOIL>,<DEP>,<SITE>,<POINT>,<HOUSE>,<DEP>,<FORCE>,<ANALYS>,<COMBIN>,<MOTION>,<STRESS>,<RELDISP>

sets the AFWRITE and CHECK options for modules. If <opt> is zero, the corresponding module will not be taken into account by the AFWRITE and CHECK instructions (see sections and ).

<EQUAKE> – Flag for Equake module
<SOIL> – Flag for soil module
<DEP> – Flag for module that has been depreciated in current version ACS-SASSI should always be 0
<SITE> – Flag for site module
<POINT> – Flag for point module
<HOUSE> – Flag for house module
<FORCE> – Flag for force module
<ANALYS> – Flag for analys module
<COMBIN> – Flag for combin module
<MOTION> – Flag for motion module
<STRESS> – Flag for stress module
<RELDISP> – Flag for reldisp module

Note: This instruction is provided for input files. To set the analysis options for the AFWRITE and CHECK instructions from the ACS SASSI PREP and Submodeler , use the Options / Analysis command.