AOPT,<EQUAKE>,<SOIL>,<DEP>,<SITE>,<POINT>,<HOUSE>,<DEP>,<FORCE>,<ANALYS>,<COMBIN>,<MOTION>,<STRESS>,<RELDISP>,<NONLIN>

sets the AFWRITE and CHECK options for modules. If <opt> = 0, the corresponding module will not be taken into account by the AFWRITE and CHECK instructions.

• <EQUAKE> – Flag for Equake module
• <SOIL> – Flag for soil module
• <DEP> – Flag for module that has been deprecated and no longer included in current version ACS-SASSI. These should always be 0
• <SITE> – Flag for site module
• <POINT> – Flag for point module
• <HOUSE> – Flag for house module
• <FORCE> – Flag for force module
• <ANALYS> – Flag for analys module
• <COMBIN> – Flag for combin module
• <MOTION> – Flag for motion module
• <STRESS> – Flag for stress module
• <RELDISP> – Flag for reldisp module
• <NONLIN> - Flag for the nonlinear module

Note: This instruction is provided for input files. To set the analysis options for the AFWRITE and CHECK instructions from the ACS SASSI PREP and ACS-SASSI User Interface, use the Options / Analysis command.