MOTION,<opmode>,<out>,<fsave>,<dur>,<res>,<freq1>,<freq2>,<fstep>,
<mult>,<max>,<rec1>,<rec2>,<fopt>,<bl>,<smo>,<cplx>,<cnvrt>,<pzadj>, <interp>
defines the following analysis options for ACS SASSI MOTION module:
<opmode> - operation mode
0 - complete solution
1 - data check only
<out> - output option
<fsave> - Save File 12/13
0 - Don't save 12 or 13
1 - Save File 13
2 - Save File 12
<dur> - total duration of time histories to be plotted
<res> - type of response
0 - output only displacements
1 - output only velocities
2 - output only accelerations
<freq1> - first frequency used in response spectrum analysis
<freq2> - last frequency used in response spectrum analysis
<fstep> - total number of frequency steps for response spectra
<mult> - multiplication factor for scaling time history
<max> - maximum value of time history to be used. The values of time history will be scaled to the given maximum value.
<rec1> - first record of time history file to be written to analysis file
<rec2> - last record of time history file to be written to analysis file (default: last record from file)
<fopt> - time history file option
0 - file contains time step on the first line, one acceleration on each other line
1 - file contains pairs of time step and acceleration on each line
<bl> - baseline correction
0 - no correction
1 - with correction
<smo> - smoothing parameter
<cplx> - determine if the RS will be complex or not
<cnvrt> - motion convert?
<pzadj> - Phase Adjustment parameter
<interp> - Motion interpolation Option
Note: This instruction is provided for input files. To set the analysis options for the ACS SASSI MOTION module from the ACS SASSI PREP or SASSI User Interface, use the Options / Analysis menu option.