ACS SASSI Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== WALLFLR Command ======

WALLFLR

The WALLFLR command will take the current active model and delete all of the non shell elements in the model Then the command will attempt to separate all of the shells into different wall and floors groups based on a coplanarity test of the shell elements. If 5 or more elements are found to be coplanar these elements will be put into a new group. All of the elements that were not put into walls or floor groups because there were not enough coplanar shells to form a new wall or floor will be found in group 1.

Each of the walls & floors will be labeled using the group title [[ com:GTIT ]]. The titles are based on if the group is the parallel to a dimension of the global coordinate system or if the wall is oblique of the global coordinate system.

Once this Command is complete the model is considered to be a panel model. The user may use this panel model for [[ example:Non-Linear Modeling ]], or the user can further split the model using the [[ com:PANELIZE ]] command.

ACS SASSI Documentation

User Tools

Site Tools

Page Tools