ACS SASSI Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== SOILMESH Command ======

SOILMESH,< dest >,< sX >,< sY >,< hori> ,<vert >,< xAdj>,<yAdj>,<Zdepth>,<contact>,<rNum>

This command allow the user to make a soil field mesh for a model. This mesh is used to analyze pressure on the excavation volume.  The basement must be a continuous convex hull that has uniform external wall along all layers. 

  * dest – destination model number
  * sX  - floating point  percentage of growth in the X direction of each level    
  * sY –  floating point  percentage of growth in the Y direction of each level 
  * hori – number of new  horizontal layers
  * vert – number of vertical vertical layers
  * xAdj – floating point Centroid correction in the X direction
  * yAdj  – floating point  Centroid correction in the Y direction
  * Zdepth -  floating point Thickness of each new level in the Z direction
  * contact –  if equal 0 do not use contact surfaces, else include contact surfaces in the model. 
  * rNum – the real property number for the contact surface

**Note(s)**: This command created before [[com:MERGE]] and other model combination commands existed. It is recommended that the model created by this command should be saved using [[com:WRITE]] then loaded over the original model to create the soil pressure model.

ACS SASSI Documentation

User Tools

Site Tools

Page Tools