ACS SASSI Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== SLICE Command ======

SLICE, <cutnum>,<pointx>,<pointy>,<pointz>,<normalx>,<normaly>,<normalz>

This command will load a cut defined by cutnum with all of the elements that cross an infinite plane defined by the users point and normal entry. The Slice command as of version ACS-SASSI User Interface 1.0.1 will add all of the new elements found by slice to the cut defined by cutnum already in memory. In versions of the user interface before 1.0.1 and all version of Submodeler this command will replace the cut defined by cutnum. This change was made so the command functions like the other cut commands [[com:CUTADD]] and [[com:CUTVOL]]  
 
  * cutnum – number of the cut
  * pointx – x of point on the plane
  * pointy - y of point on the plane
  * pointz - z of point on the plane
  * normalx – x of the normal of the plane
  * normaly – y of the normal of the plane
  * normalz – z of the normal of the plane

ACS SASSI Documentation

User Tools

Site Tools

Page Tools