ACS SASSI Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== FILLPOOL Command ======

**FILLPOOL**,[Stiff],[Sensitivity]

This command fills a pool with solid water elements, a spring water/pool wall interface and the surface area of the interface using shells. The pool is filled using an algorithm used in the [[com:EXCAV]] command where the floor of the pool and the wall Z-levels are used to create group solid elements to fill the volume. The interface of the pool wall/water are connected by a set of springs with the stiffness of these springs determined by user input. Finally a shell group is added that approximates the areas of the interface which may be useful in further processing of the pool in ANSYS(r).

The user should create a sub-model of the pool to be filled before using this command. The pool model should only contain the walls and floor of a single pool to be filled. The walls and floor must be made of either shells or solids. 

  * Stiff - Stiffness of the Water wall spring interface (Default 10<sup>6</sup>)
  * Sensitivity -  allowable variation in Z on the same Z-level (Default 0)

ACS SASSI Documentation

User Tools

Site Tools

Page Tools