ACS SASSI Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== CALCSECTHIST Command ======

CALCSECTHIST,<infile>,<cutnum>,<pointx>,<pointy>,<pointz>,<normalx>,<normaly>,<normalz>,<rightx>,<righty>,<rightz>,<sysno>,[ts],<outfile>

Calculates forces for a cross-section based on a stress history file. This allows the user to batch the force calculation of a cut for every timestep of the model. The results data will then be written to the outfile.

  * infile – Full path of the input file for the element center stress history. Similar format Animation list file for prep 
  * cutnum – The cut to be used
  * pointx – x of point on the plane
  * pointy - y of point on the plane
  * pointz - z of point on the plane
  * normalx – x of the normal of the original cut  plane in global coordinated
  * normaly – y of the normal of the original cut  plane in global coordinated
  * normalz – z of the normal of the original cut  plane in global coordinated
  * rightx – x of the local right in global coordinates   
  * righty – y of the local right in global coordinates
  * rightz – z of the local right in global coordinates
  * sysno – the system number where the local system will be stored
  * ts - timestep for each calculation. If ts <= 0  the integer position in the infile will be used.    
  * outfile – full path of the output file for the force history.

ACS SASSI Documentation

User Tools

Site Tools

Page Tools