Differences

This shows you the differences between two versions of the page.

--- com:soilinter [2015/10/13 10:51]
phil
+++ com:soilinter [2016/05/10 14:30] (current)
phil
@@ Line 2: / Line 2: @@
 SOILINTER,<soil>,<dir>,<tol>
+NOT APPLICABLE TO CURRENT VERSION
 Transfer the interaction node area from a 3d excavation model onto a 2d soil model.
+Both models should be in ACS-SASSI User Interface memory before using this command. The user should select the 3D model to be changed by using the [[com::ACTM]] before using this command. This command will only change the interaction status of nodes on the 2d soil model.
-This command should be used when the 3d model is active. The ground elevation of the 3d model must be defined for this command to transfer the area properly
+The user must define the interaction node on the 3d model before using this command. The 2d soil model should always be defined along the x-z axis. The dir command allows the user to select if the x-z area or the y-z area of the interaction nodes will be applied to the 2d soil model. the tol argument is a floating point distance past the interaction area where the interaction nodes will be created in the 2d soil model.
   * soil - the 2d soil model number

ACS SASSI Documentation