User Tools
com:aopt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
com:aopt [2016/04/27 10:48] phil |
com:aopt [2016/05/26 10:59] (current) phil |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== AOPT Command ====== | ====== AOPT Command ====== | ||
| - | AOPT,<EQUAKE>,<SOIL>,<DEP>,<SITE>,<POINT>,<HOUSE>,<DEP>,<FORCE>,<ANALYS>,<COMBIN>,<MOTION>,<STRESS>,<RELDISP>,<PANEL> | + | AOPT,<EQUAKE>,<SOIL>,<DEP>,<SITE>,<POINT>,<HOUSE>,<DEP>,<FORCE>,<ANALYS>,<COMBIN>,<MOTION>,<STRESS>,<RELDISP>,<NONLIN> |
| sets the [[com:AFWRITE]] and [[com:CHECK]] options for modules. If <opt> = 0, the corresponding module will not be taken into account by the AFWRITE and CHECK instructions. | sets the [[com:AFWRITE]] and [[com:CHECK]] options for modules. If <opt> = 0, the corresponding module will not be taken into account by the AFWRITE and CHECK instructions. | ||
| Line 7: | Line 7: | ||
| * <EQUAKE> – Flag for Equake module | * <EQUAKE> – Flag for Equake module | ||
| * <SOIL> – Flag for soil module | * <SOIL> – Flag for soil module | ||
| - | * <DEP> – Flag for module that has been deprecated in current version ACS-SASSI and should always be 0 | + | * <DEP> – Flag for module that has been deprecated and no longer included in current version ACS-SASSI. These should always be 0 |
| * <SITE> – Flag for site module | * <SITE> – Flag for site module | ||
| * <POINT> – Flag for point module | * <POINT> – Flag for point module | ||
| Line 17: | Line 17: | ||
| * <STRESS> – Flag for stress module | * <STRESS> – Flag for stress module | ||
| * <RELDISP> – Flag for reldisp module | * <RELDISP> – Flag for reldisp module | ||
| - | * <PANEL> - Flag for the panel module | + | * <NONLIN> - Flag for the nonlinear module |
| **Note:** This instruction is provided for input files. To set the analysis options for the [[com:AFWRITE]] and [[com:CHECK]] instructions from the ACS SASSI [[SASSI:PREP]] and [[SASSI:acs-sassi_user_interface|ACS-SASSI User Interface]], use the Options / Analysis command. | **Note:** This instruction is provided for input files. To set the analysis options for the [[com:AFWRITE]] and [[com:CHECK]] instructions from the ACS SASSI [[SASSI:PREP]] and [[SASSI:acs-sassi_user_interface|ACS-SASSI User Interface]], use the Options / Analysis command. | ||
com/aopt.1461768497.txt.gz · Last modified: 2016/04/27 10:48 by phil
Page Tools
(C) 2013-2019 Ghiocel Predictive Technologies
